|
Description 
These new 70W, 3" x 5", medical grade power supplies are designed with Skynet`s patented Ring-Free ZVS technology to ensure high efficiency and compact size.
This series features Active PFC; low leakage current and FCC & VDE class B EMI. Meanwhile, it complies with a wide variety of safety regulations so that it can be used in Medical, Industrial, Information Technology or other equivalent applications.
Features
• Low leakage current
• FCC & EN55011 class “B"; EN61000-3-2 class “A”
• UL2601, CSA 22.2 NO.601.1, EN 60601-1
• Up to 90% efficiency
• Active power factor correction
• Meets IEC-1000-3-2 harmonics
Size
3 x 5 x 1.18 inch
76.2 x 127 x 30 mm
|
DC Outputs
| Output | +12 VDC | 5V | |
Max Load | 5.6A / 9A pk | 0.5A | |
Regulation | +/-1% | +/-1% | |
Ripple | 120mV | 50mV | |
|
|
|
|
Specifications
View Specifications in PDF Format
| Input |
VAC
|
| Voltage, V |
90 to 264
|
| Frequency, Hz |
47 to 63
|
| Current, A |
inrush I <30A at 115VAC;
<60A at 230VAC
|
| Power Factor |
Active PFC
|
| Harmonics |
EN61000-3-2
|
 |
|
| Cooling |
Free air convection for 100W
18 CFM forced air
|
| Power Good |
consult factory
|
| Holdup Time |
20 mS typical
at rated load and 115VAC
|
| Transient |
consult factory
|
| Efficiency |
80%~90% depending on model
|
| Shorted output |
Protected
|
| Over Load Protection |
Auto-recovery
|
| Short Circuit Protection |
Auto-recovery
|
| Over Voltage Protection |
Latch-off
|
| EMS |
EN61000-4-2, -3, -4, -5, -6, -11
|
| Temperature |
0 to 50 degrees C
|
| EMI |
EN55022
|
| Safety Agency |
UL 60950, CSA 22.2 No. 234 and EN60950
|
Notes |
1. The total output current is rated load with free air convection and maximum load.
2. Each output is checked at the factory to be within voltage accuracy with a 60% rated load condition.
3. Line regulation is defined by changing the input voltage ±10% from nominal line at rated load.
4. Load regulation is defined by changing the output load ± 40% from 60% of the rated load while another output is set to 60% of rated load.
5. Ripple & noise is measured at rated load and nominal line by using a 15MHz bandwidth limited oscilloscope with each output terminated by a 0.47 uF capacitor.
6. Hold up time is measured from the end of the last charging pulse to when the main output drops down to 95% output voltage.
7. Efficiency is measured at rated load.
|
Mechanical |
