Description

Skynet’s new flagship product is a 3" x 5" open frame power supply with an amazing power density of 6 watts per cubic inch plus active PFC. The 3” x 5” form factor has been an industry standard for more than 10 years. Initially the power density was around 2 watts per cubic inch then hovered around 3 watts per cubic inch for quite some time. Now the SNP-Z series in 3" x 5" form factor is undoubtedly the current state-of-the-art. With built-in PFC

Features

Size

DC Outputs

Specifications
View Specifications in PDF Format

Input	VAC
Voltage, V	90 to 264
Frequency, Hz	47 to 63
Current, A	inrush I <30A at 115VAC; <60A at 230VAC
Power Factor	Active PFC
Harmonics	EN61000-3-2
Cooling	Free air convection for 100W 18 CFM forced air
Power Good	consult factory
Holdup Time	20 mS typical at rated load and 115VAC
Transient	consult factory
Efficiency	80%~90% depending on model
Shorted output	Protected
Over Load Protection	Auto-recovery
Short Circuit Protection	Auto-recovery
Over Voltage Protection	Latch-off
EMS	EN61000-4-2, -3, -4, -5, -6, -11
Temperature	0 to 50 degrees C
EMI	EN55022
Safety Agency	UL 60950, CSA 22.2 No. 234 and EN60950

Notes

1. The total output current is rated load with free air convection and maximum load. For 130w rating 18 CFM of forced airflow is provided over the unit. 2. Each output is checked at the factory to be within voltage accuracy with a 60% rated load condition. 3. Line regulation is defined by changing the input voltage ±10% from nominal line at rated load. 4. Load regulation is defined by changing the output load ± 40% from 60% of the rated load while another output is set to 60% of rated load. 5. Ripple & noise is measured at rated load and nominal line by using a 15MHz bandwidth limited oscilloscope with each output terminated by a 0.47 uF capacitor. 6. Hold up time is measured from the end of the last charging pulse to when the main output drops down to 95% output voltage. 7. Efficiency is measured at rated load.

Mechanical